Register or have you forgotten your password?
|
|
Register or have you forgotten your password?
|
All times are GMT -6. The time now is 01:13 AM.
| Welcome to Forum, please register to access all of our features.
|
|
| Amiga Software Issues and Discussion This forum exists for the discussion of the use, issues with, and fun brought about by classic and next generation Amiga software. |
 |
|
|
Thread Tools | Display Modes |
10-14-2010, 06:28 AM
|
#1 | ||||||||
|
Kindred of Babble-on
Join Date: Dec 2003
Location: Serbia
Posts: 2,532
|
LCD out of sync
sorry for this newbie question, its been a while since I installed wb.
I am trying to install WB3.1 onto A4000 with PicassoIV card. early startup menu shows up fine, CLI after "boot without startup sequence" also looks good. but whenever I try to boot workbench, monitor (HP LP2065) gives error out of sync. do I have to use another monitor to install P96 drivers first?
__________________
You`re here, Noŷs. |
||||||||
|
|
|
10-14-2010, 07:11 AM
|
#2 | ||||||||
|
Technoid
Join Date: Feb 2010
Posts: 312
|
Re: LCD out of sync
I'm sure I read in the manual when I recently installed my PicassoIV that if you have any monitor driver other then PAL or NTSC in Devs:Monitors then you will have problems booting into Workbench the first time, this is something you should check.
The PicassioIV has a Video slot Scan Doiubler so should be able to display both native and RTG screens on your Monitor, I guess if worst comes to worst you'll have to install using another screen but if this is the case then maybe some of the software you run (i.e games that use Native screens) may also give you 'out of sync' Steve. |
||||||||
|
|
|
| Bookmarks |
| Tags |
| sync , lcd |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
