lunithy

Have been flat out working on cars and junk and finally got a chance to have a go at getting the HD to boot into work bench.... so holding the key board plug in place I tried but no good .... ya can't do much without it so I was curios and had a look with my multimeter just to see if thing were getting current accompanied by the pin out and as far as I could tel all was good but that's when I put the leads down not paying any attention and blue a pico fuse I herd it! you know the one...

Well got a visit from Cammy and Rebel-CD32 with some bits on the week end to get me under way, Cammy and Rebel spent a fare amount of time explaining things to me and have been very kind to loan me the hardware till I get my own
A ROM switch and card reader with 2g card and lots of 3.5 floppy's but the A2091 gave us some fun in that it would not show any other devices and the K board did not won't to play ball flashing red light but we did get to check the ram and the HD which...

Well after some advice from members here I unplugged the HD and got this.

So I put Work Bench and walla!

And Power Monger one of my favorite's all I need now is a Key baord and Classic WB.

OK today I got a HD from gertsy thanks mate much appreciated and was stoked to put it all back together again.
All I need now is a Key board and to work out how to boot it up

For a while now I,v had an old A2000HD sitting in the shed with the bikes and tools so I thought I'd get it out and resurrect it to working order.
So I decided to keep a blog of how it goes from a noobs point of view and so far I have to say everyone in here has been great with advice and even parts, there is just so much info to read and learn!.

I have allays had a few A500's around just to bang away...