View Full Version : MicroniK PCI 1200 busboard power connector
01-03-2007, 11:24 AM
I bought a MicroniK 6860 Zorro 2 busboard for my A1200T.
There is a power connector on the busboard but I do not know the pinouts since it is meant to be used in an Infinitiv Tower and with its MicroniK PSU.
I heard that in the manual of this busboard the power pinout of this connector is shown. Can anyone scan this or perhaps measure their MicroniK PSU?
Also, on the Videoslot adapter there is a 6 pin connector, where should that connector be connected?
01-03-2007, 11:55 AM
there is a special videoslot enabler for the board...
they are very hard to find tho :)
looking for one myself
01-03-2007, 12:03 PM
I have that video slot enabler, but my has a six pin cable to plug somewhere also, but I do not know where it will fit.
01-03-2007, 12:23 PM
on amiga hardware it says:
To use the Video Slot may require the use of the video slot enabler. It clips over the top of various chips on the A1200 motherboard, at the following locations, U30, U7, U8.
i have no idea where those locations are on the a1200 mobo tho
01-03-2007, 12:41 PM
Yeah that is right. I have two clips that clips over various chips on the motherboard. But then I have a small 6-pin connector that should be mounted on some kind of pinheader somewhere, but where?
01-03-2007, 03:11 PM
is that from the videoslot enabler or from the keyboard adapter ?
the keyboard adapter has a 6pin connector
01-03-2007, 04:16 PM
Yeah exactly I have one of those 6 pin connectors, but it is comming from the videoslot enabler! It is a bit different, it has 5 pins but the third pin from the top is empty. Perhaps it works without it but I have no scandoubler to test it :-/
01-05-2007, 03:49 AM
well from what i can see it looks like a keyboard connector
i could be wrong tho since i only have the z3i board and not the videoslot enabler :)
01-05-2007, 04:30 AM
Amigakit sells Micronik <> AT(X)psu adapters.
I used use one.
vBulletin® v3.8.4, Copyright ©2000-2013, Jelsoft Enterprises Ltd.