Progressive 2000/040 Jumper Settings or Manual [Archive]

View Full Version : Progressive 2000/040 Jumper Settings or Manual

BoingBoss

07-07-2004, 10:31 PM

Hi everybody,

I installed a Progressive 2000/040 board in my Amiga 2500 computer today. My computer was working fine before I installed this board, but now I get a blinking power light and a green screen. Does anyone know how to set the jumpers on the Progressive 2000/040 board? Or can anyone email me the manual?

The jumpers look like this:

A IIII B IIII C IIII

1234 1234 1234

adolescent

07-07-2004, 10:44 PM

Check here (http://www.dpmworld.net/AmigaGallery/pps/).

BoingBoss

07-07-2004, 11:37 PM

Thanks, that helped. :-D

adolescent

07-07-2004, 11:50 PM

No problem. They're good cards. I have a Mercury 040/35MHz in my A3000 Professional Computer.

BoingBoss

07-08-2004, 12:06 AM

Are you sure it is "professional"? :lol:

BoingBoss

07-08-2004, 01:13 AM

Well the board works until I install the software, then it just hangs on bootup. Also, the 8 1-meg simms do not show up in SysInfo or in Workbench. I am at a loss.

Roj

07-08-2004, 01:41 AM

I used FastExec (ftp://de.aminet.net/pub/aminet/util/boot/FastExec29.lha) from Aminet to make my old PP&S Zeus' RAM available, plus a few other odds and ends. This is the line I had before SetPatch:

C:FastExec AddMem 0x8000000 0x2000000 5 10 Address 0x8000000 FastExp FastSSP FastVBR FastMEM FastINT Reboot

Depending on the amount of RAM installed, you'll have to adjust the second value after ADDMEM. 0x2000000 enables 32MB. For 8MB you'd use 0x800000. I'll let you figure out other values. ;-)